-
Use and Maintenance of Dust Filter Bag
May 21 , 2021
The general problems and precautions of the operation and maintenance of the dust filter bag can be divided into three aspects: excessive dust emission, higher than normal pressure of the filter, and short service life of the dust filter bag. There is a significant correlation between the three. The brief introduction is as follows: The basic cause of dust emission overruns caused by excessive dus...
Read More
-
Common faults and treatment solutions of dust filter bag
May 28 , 2021
Industrial dust collector is a kind of air pollution control equipment used in factories, workshops, warehouses and other industrial or commercial environments to meet the safety requirements of the environment and workplaces. However, improper use will also cause certain failures of the dust collector. For the common failures of the dust filter bag and their treatment methods, I will introduce to...
Read More
-
Best Time to Replace the Dust Collector Filter Bag
Jun 04 , 2021
Replacing the dust collector filter bag too early will increase unnecessary costs and take up maintenance time, which could have been better used for more urgent tasks. Replacing the filter bag of the dust collector too late may expose workers in the facility to dangerous dust and may cause a fire or explosion. In addition, as the filter becomes more and more clogged, the energy cost of the compre...
Read More
-
What are the characteristics of pleated bags?
Jul 08 , 2021
(1)Pleated Filter bags with the same diameter can increase the filter area According to the needs of the system and the existing design, the pleated filter bag is installed and operated the same as a round (elliptical) bag, and no special structural adjustment is required. The multi-pleated structure of the filter bag itself makes the filter area larger than that of the ordinary round (elliptical)...
Read More
-
3 High Temperature Filter Cloth Fiber
Jul 16 , 2021
1.PPS Fiber Chemical structure: polyphenylene sulfide. The fiber has excellent acid and alkali resistance and good wear resistance. The fiber working temperature is 130-170 ° C, the general continuous use temperature is 160 degrees or less, the short-time working temperature is 190 ° C, and the melting point is 285 ° C. It is also the core material of PPS Filter Bag. In normal use, the oxygen cont...
Read More
-
2 Low Temperature Filter Cloth Fiber
Jul 23 , 2021
1.Polyester Fiber Polyester staple fiber is made of polyester (ie polyethylene terephthalate) Referred to as PET, polymerized from PTA and MEG), it is re-spun into a fiber obtained by cutting the tow. PET is in the form of rice grains or flakes, and the variety and color are different. (The main ingredient of the beverage bottle that we usually touch is polyester. It is sliced. Genera...
Read More
-
The dust removal effect of the dust collector is poor, is the filter bag selected correctly?
Aug 06 , 2021
The dust filter bag is the core component of the bag filter, which directly affects the use effect of the bag filter. Take the cement industry as an example, dust collectors often have air duct wear, blockage or dust collection; the air pressure of the fan in the dust collection system is not enough, resulting in a decrease in the efficiency of the equipment; the resistance of the dust collector i...
Read More
-
Common Faults And Cause Analysis Of Bag Filter-Solenoid Valve Does Not Operate Or Leaks
Aug 10 , 2021
Common faults and cause analysis of bag filter-solenoid valve does not operate or leaks Cause Analysis: (1) The coil is damaged, open circuit, poor contact, and the controller has no signal. (2) The diaphragm is damaged and deformed, impurities are stuck on the diaphragm, the diaphragm cannot be reset normally, the spring fails or the vent is blocked. (3) How much blowing pressure damages the comp...
Read More
-
Common faults and cause analysis of the bag filter-the resistance increases beyond the normal value, and the resistance cannot be reduced after the dust removal operation
Aug 20 , 2021
Cause Analysis: (1) Pouch paste phenomenon occurs. (2) The ash cleaning device fails, and there is no ash cleaning effect. (3) The cleaning effect is not good. (4) The filtration rate is too high. Approach: (1) When handling paste bag filter bags, use oil-proof, anti-static, and waterproof filter cloth, and adopt heat preservation measures to avoid condensation and cause paste bags. It is also pos...
Read More
